Difference between revisions of "IN - Insulators"

From RadioNerds
Jump to navigation Jump to search
Line 63: Line 63:
 
* [[IN-100]]
 
* [[IN-100]]
 
* [[IN-101]] porcelain, 1,5/8" with cotter clip. for vehicle penetration. Porcelain Bushings (Long version) U/W vehicular radios
 
* [[IN-101]] porcelain, 1,5/8" with cotter clip. for vehicle penetration. Porcelain Bushings (Long version) U/W vehicular radios
* [[IN-102]]
+
* [[IN-102]], [[SCR-197]], mast section, [[MS-65]] ??
* [[IN-103]]
+
* [[IN-103]], [[SCR-197]], mast brace [[MP-40]] ??
 
* [[IN-104]], stand off, porcelain disk held by rod threaded on one end  
 
* [[IN-104]], stand off, porcelain disk held by rod threaded on one end  
 
* [[IN-105]]
 
* [[IN-105]]

Revision as of 14:42, 26 April 2016

changed to IL- under JETDS

  • IN-1, strain, Hard rubber insulator, with hooks
  • IN-2, strain, Ball-type, Electrose 4500 without hooks
  • IN-3, Dielecto, "streamline"
  • IN-4, strain, S.G.D.P. Electrose 3001
  • IN-5, strain, Hard rubber rod, 5.5 x .625"
  • IN-6, mast top, bakelite with brass cap, threaded for pin FT-3
  • IN-7, pin type, for mast top,
  • IN-8, strain, phenol fiber rod, Phenolic rod, 4"
  • IN-9, Separator
  • IN-10, strain, Micarta, with hooks or clevises

(No record of IN-11 to In-52)

  • IN-53, wooden knob, single groove.
  • IN-54 ?
  • IN-55, strain, Hard rubber, later porcelain with end hooks for antenna AN-4
  • IN-56, double groove, double petticoat, Porcelain, with lag screw,
  • IN-57, wooden knob, single groove.
  • IN-58, wooden knob, single groove.
  • IN-59, wooden knob, single groove.
  • IN-60, Knob, trench type, made of electrose, single groove.
  • IN 61, strain, Porcelain rod, 18" X 1.5 Dia
  • IN-62, pigtail, for lance poles, di-molded mica, (curly-que wire out the top of the insulator)
  • IN-63, clamp for lance pole, di-molded mica,

(NOTE 1920 storage catalog ends here)