AN/GRR-5

From RadioNerds
Revision as of 01:48, 23 September 2013 by RadioNerds (talk | contribs)
Jump to navigation Jump to search
AN/GRR-5


Images


Power Hookups

The AN/GRR-5 Radio has an exceptionally flexible power input specification. This radio can operate on 6, 12, or 24 Volts DC as well as 115 Volts AC. The voltage is determined by a switch on the front of the power supply or automatically in the case of 115 Volts AC.

hookups for each power range is made by different pins on the J103 Power plug. They are as follows:

6, 12, 24 Volts DC
Pin C - Ground
Pin B - 6, 12, 24 Volts DC
115 Volts AC
Pin D - AC
Pin A - AC
Idea.png
Grounding and Shock Hazards when in AC Power Mode
The AN/GRR-5 and similar era radios have a tendency to have voltage on the radio case when powered by AC sources. This is due to the lack of a ground lug on the factory power cord, and filter capacitors inside the radio that are connected to the radio case. This voltage can cause an uncomfortable shock, although its usually not fatal. Solutions can be found below in "Recommended Modifications" to remedy this.


Recommended Modifications

The AN/GRR-5 is an excellent radio, however during the time of its manufacture, some safety features we come to expect were not implemented. The following items are recommended enhancements that will make the device safer to use with modern electrical systems. All of these recommended procedures are fully reversable should you wish to return the radio to its factory condition.


Add a Grounded Power Cable

Replace the factory 2 conductor plug and cord with a modern 3 prong grounded plug. To do this, unsolder the factory plug from the power cord and replace it with a modern, 3 plug type. Use the following pinout for hookups:

115 Volts AC
Pin A - AC
Pin C - Ground
Pin D - AC

Additional Files

Adobe PDF icon.png TM 11-295

Radio Receiving Set
AN/GRR-5
August 1952